Why do log homes continuously have rotten logs? So far, the best way to keep this problem from happening is by doing the process of chinking properly. It is to seal the elements permanently. The main reasons causing this problem is improper installation of caulking and improper application of chinking.
What else can it do to your log homes? It can change the interior’s appearance in several ways. You can choose to intensify the brightness by using light colors, contrasting colors or same colors to blend with the stain.
How to do the correct process of log home chinking?
These steps will guide you in doing the process correctly.
1) The first thing to do is to clean the log’s surface and make sure it is dry.
2) Apply the chinking synthetic and maintain adhesion for about two inches. You can do this by applying first a bond breaker tape or backer rod.
3) Next is to apply the chinking product. You can use a caulking gun, grout bag, putty knife or spatula.
4) Lastly, use a trowel, putty knife, spatula or foam brush to smoothen the surface.
Tip: Do the log chinking according to your capability and speed. If possible, the material must be tooled immediately after application. You can allow 15 to 30 minutes only for interval but no more than that or else it will skin over.
Do you think you can do the process on your own? Only you can answer this question. Chinking can be considered an art; it must involve your interest, ability and speed. You must have the passion and determination to complete the project. When done properly, it will pay you in providing comfort, protection and increase the resale value of your log homes.
What else can it do to your log homes? It can change the interior’s appearance in several ways. You can choose to intensify the brightness by using light colors, contrasting colors or same colors to blend with the stain.
How to do the correct process of log home chinking?
These steps will guide you in doing the process correctly.
1) The first thing to do is to clean the log’s surface and make sure it is dry.
2) Apply the chinking synthetic and maintain adhesion for about two inches. You can do this by applying first a bond breaker tape or backer rod.
3) Next is to apply the chinking product. You can use a caulking gun, grout bag, putty knife or spatula.
4) Lastly, use a trowel, putty knife, spatula or foam brush to smoothen the surface.
Tip: Do the log chinking according to your capability and speed. If possible, the material must be tooled immediately after application. You can allow 15 to 30 minutes only for interval but no more than that or else it will skin over.
Do you think you can do the process on your own? Only you can answer this question. Chinking can be considered an art; it must involve your interest, ability and speed. You must have the passion and determination to complete the project. When done properly, it will pay you in providing comfort, protection and increase the resale value of your log homes.
RSS Feed